Amana DigiSmart PTC models Spezifikationen PDF herunterladen (Seite 13)

SS-DPTAC www.amana-ptac.com 13

SPECIFICATION SHEET

NEW INSTALLATIONS TYPICALLY REQUIRE A MINIMUM OF WS900D WALL SLEEVE

AND AN OUTDOOR GRILLE.

Wall Sleeves (WS900D)

The wall sleeve must be industry-accepted dimensions:

14⅛” depth x 42” width x 16

/16” height and con struct ed

of G90 HDG galvanized steel with a baked corrosion-

inhibiting urethane primer and baked-polyester topcoat

enamel. Sleeve must be insulated and shipped with a

weather resistant rear closure panel installed.

Outdoor Grilles

Outdoor grille must be architecturally extruded,

louvered aluminum (AGK01*B), one-piece polymer-

blend injection molded louver (PGK01*B) or standard

stamped aluminum (SGK**B). All other grilles must be

submitted to the PTAC manufacturer for feasibility,

airflow characteristics and compliance with UL

regulations, where necessary.

THE OPTIONAL ACCESSORIES LISTED BELOW PERFORM SPECIFIC FUNCTIONS REQUIRED

IN SOME INSTALLATIONS.

Condensate Drain Kit (DK900D)

Attaches to the bottom of the wall sleeve for di rec tion al-

con trolled internal or external dis pos al of condensate,

defrost or rain water.

Sub-base Kit (PTSB***E)

Necessary for UL listing requirements for 265V units

(Hard Wire Kit may be substituted for Sub-base kit).

Op tion al for 230/208V units. Must be pre-wired to

facilitate ﬁ eld-electrical con nec tions and include a

NEMA 6 or 7 con ﬁ g u ra tion electrical re cep ta cle. It must

have 2 leveling screws for sleeve support and ac cu rate

unit lev el ing during installation. Lo ca tions for ﬁ eld

in stal la tion of physical disconnect switches, cartridge-

style fuse hold ers and circuit break ers must be pro vid ed.

Side-skirts must be provided with sub-bases. (PTSB000E

Non-Elec tri cal Sub-base available.)

Power Vent & Damper

Must be provided to maximize ventilation air intake to

up to approximately 95 CFM. Power vent must be off and

damper door closed when unit fan is de-energized.

Fuse Holder (included in 265V chassis)

Must be installed either in the unit or the sub-base

and must match the electrical re quire ments of the

chas sis.

Security Key Locks (KL03B)

Must be installed to prevent tampering of the unit

con trols. Unit room cabinet must also be secured to

the chassis with ﬁ eld supplied screws. UL-ap proved for

institutional use only.

Disconnect Switch

Power disconnect switch must be installed in sub-base

for use as a physical disconnect, where required by

local codes.

Duct Kits (MDK02B, EDK02B, TDK02)

Three kits must be supplied to provide ducted,

con di tioned air into a second room: a main duct kit, an

ex ten sion duct kit and a terminal duct kit.

Hydronic Heat Kit

Is required for heating functions instead of elec tric

re sis tance heaters. Unit must retain complete service

access with the kit installed. Proper water or steam

valves must be used.

Condensate Removal Pump (Heat Pumps only)

Must be installed to assist in removing the condensate

de vel oped by the heat pump operation and transfer it

to the indoor coil to dissipate into the room, adding

hu mid i ty to the room.

Circuit Breaker Kit

Must be installed in sub-base to provide overcurrent

pro tec tion for proper 230/208V amperage. Can also be

used as a physical disconnect where local codes permit

for 230/208 voltage.

Hard Wire Kit

Must be used to permanently wire chassis for hard

wire purposes. (For 265V units, Hard Wire Kit may be

sub sti

tut ed with Sub-base Kit.)

Charcoal Filter Kit -- Optional (CFK10B)

Amana

brand Activated Charcoal ﬁ lters absorb odors

caused by cigarette, pipe or cigar smoke and airborne

odors caused by mold, mildew, etc. These replacement

ﬁ lters are polyester ﬁ bers coated with activated

charcoal. Each ﬁ lter is in di vid u al ly wrapped to assure

maximum ab sorp tion and durability when installed. (10

ﬁ lters per kit.)

Thermostats

A manufacturer-approved manual, auto changeover or

pro gram ma ble traditional-wired ther mo stat must be

in stalled to pro vide full remote op er a tion of the chassis.

A Remote Es cutch eon Kit must be used to indicate

remote operation.

1 2 ... 8 9 10 11 12 13 14 15 16

Kommentare zu diesen Handbüchern

Keine Kommentare

Amana DigiSmart PTC models Spezifikationen Seite 13

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Split-System-Klimaanlagen Amana DigiSmart PTC models